MuxLab 500752 Quick Setup Manual
Read Online
Read the MuxLab 500752 Quick Setup Manual online using the built-in PDF viewer.
Key Pages of Document
© MuxLab Inc. 2017 2 Contents Introduction ............................................................................................................... 3 1. MuxLab Ethernet Switch Setup Requirements .......................................................... 3 2. Ethernet Switch Setup ............................................................................................... 4 3. 3.1. Enabling IGMP ........ ...
© MuxLab Inc. 2017 3 Introduction 1. This document covers the basic setup requirements for a Luxul Ethernet Switch. The setup examples and screen shots shown are for the Luxul model AMS-1208P, but these instructions are similar and applicable to other Luxul Ethernet Switch models. MuxLab Ethernet Switch Setup Requirements 2. All MuxLab AV over IP Transmitters and Receivers require IGMP support to be enabled on the ...
© MuxLab Inc. 2017 4 Ethernet Switch Setup 3. 3.1. Enabling IGMP Follow the steps below to enable the IGMP feature on the Ethernet Switch. For further details on navigating through the Ethernet Switch web server menus, please refer to the Ethernet Switch manual. Step 1: Access the Ethernet Switch web server - Locate the Ethernet Switch default IP address - Make sure your computer is on the same subnet as the Ethern ...
© MuxLab Inc. 2017 5 - Navigate to the menu: [Configuration → IPMC → IGMP Snooping → VLAN Configuration] - Click [Add New IGMP VLAN] Enter the settings shown below, and then click [Save] Step 3: Save the above configuration changes - Navigate to the menu: [Administration → Configuration → Save startup-config] - Click on [Save Configuration] 3.2. Enabling Jumbo Frames Follow the steps below to enable the Ju ...
© MuxLab Inc. 2017 6 Step 1: Enable Jumbo Frames - Navigate to the menu: [Configuration → Ports → Ports] - For each port, set the “Maximum Frame Size” allowed, which in this case is the value “9600”, and then click [SAVE] Step 2: Save the above configuration changes - Navigate to the menu: [Administration → Configuration → Save startup-config] - Click on [Save Configuration] Preparing for System Ins ...
© MuxLab Inc. 2017 7 8495 Dalton Road, Mount Royal, Quebec, Canada. H4T 1V5 Tel: (514) 905-0588 Fax: (514) 905-0589 Toll Free (North America): (877) 689-5228 E-mail: [email protected] URL: www.muxlab.com ...
