Indexa 1000 Installation And Operating Instructions Manual

Text of the manual

Wirefree Burglar Alarm

SYSTEM 1000 E.A.S. Installation and Operating Instructions 1. Contents 1. Contents page 1 13. System Operation 9 2. Introduction 2 14. Anti-jamming 9 3. Kit Contents 2 15. Changing the Batteries 10 4. Safety Notes 2 16. Troubleshooting 11 5. Declaration of Conformity 2 17. Maintenance 11 6. How the Syste

The Wirefree Burglar Alarm System 1000 can provide protection for flats and detached family houses. It is

simple to install and to operate. The alarm system is armed with a wirefree remote keyfob on exit from your property and disarmed on return. If, during this time, a movement is detected by the PIR, the sire

6. How the System Works

The keyfob sends an RF signal which activates or deactivates the siren. In the armed state, when a PIR senses a movement in its detection path, it sends an RF signal to the siren to activate. The siren then sounds for two minutes, and the system is in the armed state again. The system may be deactivated

Pets may also trigger an alarm. When the system is armed, keep pets out of areas protected by PIR

sensors. If this is not possible, install the PIR upside down so that there is an area beneath the rays left for the pet. In this case it is neccessary to check the detection range especially thoroughly. - How quick a movement i

10. Fitting the Batteries

We recommend you to use good quality alkaline batteries (e.g. Duracell). 10.1. Keyfob The keyfob is supplied with a 12V battery. Lightly loosen the screw at the back side of the casing, and pull out the transit battery protective tab. Retighten the screw. Press either the “ON” or “OFF”

11. Checking the Components

11.1 Keyfob To arm the siren, press the ON button on the keyfob once. The siren emits a bleep, and the LED flashes once. If the siren does not react, keep a minimum distance of 1m to the keyfob and press the ON button once more. To disarm the siren, press the OFF button on the keyfob. The siren ble

Checking the Function of the System at the Place of Installation

Before installing the PIRs and the siren, repeat the steps described in section 11.3 with the components in the positions where you want to install them (see “Planning your System”). Hold the components provisionally in the intended pos

Setting the Siren to Operating Mode

The anti-tamper jump link is factory set in disable mode with the jump link covering both pins. If the siren is installed to an even surface, the anti-tamper spring jump link is pressed down. If the siren is forced from ist mounting, the anti-tamper switch will trigger an alarm. If you

Other Security System Manuals