Technaxx 4218 Operation & User’s Manual

Text of the manual

Technaxx® * User Manual

Video Wall Clock HD 720p Clock with built-in CMOS video camera and HD video resolution for wall mounting or table and shelf The Declaration of Conformity for this device is under the Internet link: www.technaxx.de/ (in bottom bar “Konformitätserklärung”). Before using the device the first time, please read the user manual care

1280x720 with 30fps, AVI format

PIR sensor range ~3–8m with 70° angle Built-in rechargeable 1000mAh lithium polymer battery: Charging ~5 hours / Recording ~5 hours / Standby ~25 days Storage MicroSD* card up to 32GB (*not included) Circle recording: if memory card is full with data, it starts overwriting the earli

Camera = Video camera

1 Hanging hole 4 Battery 2 Microphone 5 Stand 3 Lens adjustment 6 Time adjustment

Remove back cover

There is a buckle on the back cover. When removing it (or install it again), the buckle has to be fitted exactly into the the “buckle port” � press and slide down at straight line. (1) With both hands press gently on the back cover, to snap it out of the buckle. (2) Pull it back to use it as stand to put the clock to a table or

Rear view with back cover removed

USB Charging Use the provided USB cable connect the clock to a computer for charging, or optional use the DC cable for charging. � While charging, the RED light keeps on lightening and the BLUE light keeps flashing. � When the battery is fully charged, the BLUE light turns off. It takes approx. 5 hours until the 1000mAh

DC 5V Charging

Connect the clock to a socket with the included DC cable � the RED light turns on. It takes approx. 5 hours until the 1000mAh battery is fully charged. The clock can be charged via the DC port while the camera is recording at the same time. Make sure an MicroSD card is plugged in the slot before starting recording! Power ON Switch Power butt

� To start manual recording � press the power “P” function button

about 3 seconds � the RED light flashes 4 times and then the BLUE light turns on � then light turns off � the camera starts recording directly (it is regular recording, not PIR recording!). � To stop manual recording and to save the video � press the power �

Time and date setting

Set the time and date in the text file „time.txt“ as follows: Create a text file in the root directory named "time.txt". � Then open the text file. � Type in date and time as follows (example): 2017 02 25 10:50:00 � Then save the file and close it. Create „time.txt“ � Connect the clock a PC/Notebook (USB cable included)

Other Clock Manuals