Datalogic QuickScan L QD 2300 Quick Reference Manual

959 Terry Street Eugene, Oregon 97402 USA Telephone: (541) 683-5700 Fax: (541) 345-7140 An Unpublished Work - All rights reserved. No part of the contents of this documentation or the procedures described therein may be reproduced or transmitted in any form or by any means without prior written permission of Datalogic Scanning, Inc. or its subsidiaries or affiliates ("Data- logic" or “Datalogic Scanning”). Owners of Datalogic products are hereby granted a non-exclu- sive, revocable license to reproduce and transmit this documentation for the purchaser's own internal business purposes. Purchaser shall not remove or alter any proprietary notices, including copyright notices, contained in this documentation and shall ensure that all notices appear on any reproductions of the documentation. Should future revisions of this manual be published, you can acquire printed versions by contact- ing your Datalogic representative. Electronic versions may either be downloadable from the Data- logic website (www.scanning.datalogic.com) or provided on appropriate media. If you visit our website and would like to make comments or suggestions about this or other Datalogic publica- tions, please let us know via the "Contact Datalogic" page. Disclaimer Datalogic has taken reasonable measures to provide information in this manual that is complete and accurate, however, Datalogic reserves the right to change any specification at any time with- out prior notice. Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U. All other brand and product names may be trademarks of their respective owners. This product may be covered by one or more of the following patents: D606544 • EP870761 • Other Patents Pending

1 Connect/Disconnect Cable Connect Host Interface Keyboard Wedge Interface RS-232 Interface USB Interface 1 2

Quick Reference Guide 3 Parts of the Scanner Scanning Modes The scanner can operate in two modes: • Trigger Single Mode - trigger button must be pressed to emit the laser in order to a scan barcode. or • Stand Mode - scanner laser is in constant on state and no trigger button press is required to scan a barcode. To toggle between modes, scan the “Toggle Scan Mode” barcode below. Depending upon which mode the scanner currently is in, scan the “Toggle Scan Mode” to switch from Trigger Single to Stand, or from Stand to Trigger Single Mode. While in the Stand mode of operation, if the scanner has not been used for several minutes it will shift to low power operation, sig- nalled by a narrowing of the scanning beam. When in low power mode, the scanner will respond to a barcode and come back to nor- mal Stand Mode operation upon seeing/reading the label. If the scanner has been idle for an extended configurable period1, it will timeout, then enter sleep mode with the scanning beam turned off. To wake the scanner from sleep mode, press the trigger button. 1. See the following topic Stand Mode Timeout Period. Trigger Scan Window LED Nose Boot Toggle Scan Mode