Magnum MD 209 Instruction Manual
Text of the manual
- 2 -
TABLE OF CONTENTS
DEAR VALUED CUSTOMER .............................................................................................. 3
UNPACKING YOUR MD 209 HYBRID AUDIO RECEIVER ............................................... 4
SETTING UP THE MD 209 HYBRID AUDIO RECEIVER ................................................... 5
SET UP OF THE INTEGRATED A
- 3 -
Dear Valued Customer
Thank you for choosing the Magnum Dynalab MD 209 Hybrid Audio Receiver. Great
care has been given to the design, manufacturing and selection of components for
the MD 209 Hybrid Audio Receiver. This complete process insures optimum
listening enjoyment for many years.
The FM Section is a special design completely researched and manuf
- 4 -
UNPACKING YOUR MD 209 HYBRID AUDIO RECEIVER
Carefully inspect all sides of the shipping carton for damage. If there are marks or
holes in the carton make note of the location in relation to the unit inside. Any
obvious dents or scuff marks should alert you to the possibility of damage. Carefully
remove the MD 209 Hybrid Audio Receiver from the end caps
- 5 -
SETTING UP THE MD 209 HYBRID AUDIO RECEIVER
1. Position the receiver away from any spot which may have extremes in
temperatures.
2. Place the receiver on a very rigid surface capable of holding 50 pounds (22 KG).
3. The heat sinks located inside the unit are used to keep the unit at a safe
operating temperature. It is important that they are not covere
- 6 -
SET UP OF THE INTEGRATED AMPLIFIER SECTION OF THE MD 209
HYBRID AUDIO RECEIVER
(All numbers correspond to the product diagram on Page 13)
CAUTION
As standard practice, you should always unplug the main power to the MD 209
Hybrid Audio Receiver whenever any source component, interconnect or
loudspeaker is being installed in your system.
Now that you hav
- 7 -
Press the Stereo button again and this will switch to Mono – the stereo light
should go out.
7. If you hear a crackling sound push the Multi-path button (7 on diagram). This will
switch the signal strength meter to indicate if the noise is a result of multi-path
(a difference in timing between the RF signal received by the tuner’s antenna and
the t
- 8 -
SET UP THE MD 209 HYRBID AUDIO RECEIVER WITH AN EXTERNAL
HOME THEATER PROCESSOR
The MD 209 Hybrid Audio Receiver is equipped with a unity gain input (A3/SSP
mode Input on the Pre-Amplifier section). This is a switchable input, meaning the
input can be used as a normal pre-amplifier input or in unity gain mode.
To Connect to a Home Theater Processor
1.