Master Meter Register Install & Remove

Step 6: Twist housing assembly 15 degrees clockwise. Use lid hinge (but not lid!) when twisting. The holes for the stopper snap pin should be a little past the midline when completed. Step 7: Insert stopper snap pin. Step 8: Use any available hard surface (in this case, screwdriver handle) to push stopper snap pin completely flush. ...

Master Meter Register Removal of Old Register: Step 1: Old version of register & housing Step 2: Remove tamper seals with screwdriver or punch. Step 3: Unscrew Mounting Screws Step 4: Pull Cover Assembly Straight Up Step 5: Remove register shroud by opening gap and pulling off of body. Step 6: Meter with register and housing removed ...

Master Meter Register Installing New Shroud and Register: Step 1: Starting position of twist on register shroud Step 2: Twist clockwise until mechanical stop. * Final position shown. Step 3: Note locating indentations on register base each 90 degrees. Step 4: Place register in shroud in preferred orientation. Ensure indentation on register engage with tabs on shroud, ...

M A N U A L / G U I D E Category: Registers Type: Register Shroud / New Design Issue: How to Install & Remove Prior Design ...