KERN ALJ Operating Manual

The application enables to count many pieces placed on the scale plate. Before it is possible to count pieces using the scale, you should determine the average weight of an individual part (unit weight), the so-called reference value. For that purpose, place a s ...

KERN ALJ When determining the liquid density, the sinker of a known volume is used (available optionally). The sinker is first weighed in the air and then in the liquid, the density of which is to be determined. The hydrostatic lift stems from the weight difference which is converted int ...

KERN ALJ conditions:  There are optimum ambient conditions to count pieces with high resolution  No diversification of the counted pieces’ weight **Minimum part weight when counting the number of pieces in standard conditions:  There are uns ...

TALJG 250-4-A TALJG 310-4-A TALJG 510-4-A Weighing range (Max) 250 g 310 g 510 g Interval (d) 0.1 mg 0.1 mg 0.1 mg Reproducibility 0.1 mg 0.1 mg 0.2 mg Linearity ±0.3 mg ±0,3 mg ±0,4 mg Settling time (standard) 4 s 4 s 4 s Minimum part weight when count ...

KERN ALJ stops, then release the button. Unit 1 Unit 2 • When switching on from the stand-by mode using the ON/OFF button, the scale will be started with the unit used most recently. • After the device is disconnected from t ...

KERN ALJ 7.1 Installation place, operation place The scales are designed to ensure reliable weighing results in standard operating conditions. The choice of a correct scale location ensures its accurate and fast operation. This is why you should follow the following rules in the locati ...

see the label to the left. Always use the original power supply. The printed voltage value must be consistent with the local mains voltage. Injury hazard, the ion source blades are very sharp. The ionizing unit generates toxic ozone, ensure ap ...

KERN ALJ pressing the PRINT button. Sample printout (KERN YKB-01N): 23-08-20 11:14:57 d: 8.0700 g/cm3 If there are any errors when determining the density, “d-----” will be displayed.  Return to the density determination mode, pressi ...

KERN ALJ 2 minutes Automatic switch off after 2 minutes with no weight change 5 minutes Automatic switch off after 5 minutes with no weight change 15 minutes Automatic switch off after 15 minutes with no weight change  Confirm the selection, pressing the PRINT button. Th ...