Spirax Sarco STAPs Quick Installation Manual

10 - 1 off lower clamp with 'T' bolt and wing nut. Size ½" - 1¼" Larger sizes use a top clamp with jubilee clips. Size 1½" to 4" - A Tadiran SL-2880 3.6 V battery will be required to power each head, and is supplied loose within the box. Fig. 3 Fig. 4 Fig. 6 Clamp for use with a Spirax Sarco STS17 or STS17.2 compact pipeline steam ...

5 1.5 Hazardous environment around the product Consider: explosion risk areas, lack of oxygen (e.g. tanks, pits), dangerous gases, extremes of temperature, hot surfaces, fire hazard (e.g. during welding), excessive noise, moving machinery. 1.6 The system Consider the effect on the complete system of the work proposed. Will any proposed ...

Spirax Sarco STAPs 19 Fig. 20 Upper (larger) heat shield Lower (smaller) heat shield The heat shield kit consists of two individual heat shields, upper and lower. Both heat shields must be fitted to achieve the optimum heat dissipation. ...

Spirax Sarco STAPs 9 Fig. 2 Slot used for size of pipe: ½" ¾" 1" 1¼" - 1 off head and sensor assembly, including the head unit and sensor. 3. Installation of the head unit assembly Note: Before actioning any installation observe the 'Safety information' in Section 1. The STAPS sensor includes the following parts: ...

Spirax Sarco STAPs 27 3.4.2 For pipe sizes 1½", 2" - 2½" and 3" - 4". The larger sizes use jubilee clips rather than a clamp to attach the head unit to the pipe.Separate the jubilee clips and slide over the pipe and slide them over the pipe, loosely tighten the clips to the pipe, allowing room to push the top clamp under. Fig. 36 Caution: If fitted to ...

Spirax Sarco STAPs 21 Fig. 23 Fig. 24 - Slide the upper heat shield (larger one) over the sensor stem - Slide larger circlip over sensor stem. ...

Spirax Sarco STAPs 12 Fig. 8 Fig. 9 - Lift housing lid. 3.1.2 Turn head cover anticlockwise to unscrew. ...

29 MAC ID 3.5 MAC ID (EUI-64) The MAC ID is a unique number to the piece of equipment it is attached to. This cannot be changed and will remain with the product for its lifetime. Fig. 41 Important: Make sure that MAC ID is noted against a trap type and reference location. This data will be required when entering or editing the configu ...

Spirax Sarco STAPs 22 Fig. 25 Fig. 26 - Using circlip pliers spread circlip and insert into groove, thus retaining heat shield. - Repeat procedure for the lower (smaller) heat shield. ...

Spirax Sarco STAPs 8 Fig. 1 2.1 General description The STAPS wireless steam trap monitoring system has been designed to efficiently monitor and evaluate steam trap operation. It surveys the operation of the steam trap at regular intervals and identifies poor performance that can cause reduced plant efficiency and increased energy consumption. It can dia ...

Spirax Sarco STAPs 16 Fig. 15 - Screw in knurled antenna nut. 3.2 Attaching the antenna Fig. 14 - Align the antenna pin with the antenna adaptor jack. Fig. 16 - Align antenna vertically and ensure the antenna nut is fully tightened. ...