Toro 30069 Operator's Manual
Text of the manual
Form No. 3390-262 Rev B
Commercial Walk-Behind
Traction Unit
18HP Pistol-Grip Hydro Drive
Model No. 30069—Serial No. 315000001 and Up
Register at www.Toro.com.
Original Instructions (EN)
*3390-262*
B
This product complies with all relevant European directives;
for details, please see the separate product specific Declaration
of Conformity (DOC) sheet.
Introduction
This rotary-blade, lawn mower is intended to be used by
residential homeowners or professional, hired operators. It is
designed primarily for cutting grass on well-maintained lawns
on residenti
Safety ........................................................................... 4
General Lawn Mower Safety ..................................... 4
Sound Pressure for the 32 RD, 36 RD and 48
RD .................................................................... 6
Sound Power for the 32 RD, 36 RD and 48
RD ........................................
This machine has been designed in accordance with EN ISO
5395:2013.
Improperly using or maintaining this mower can result
in injury. To reduce the potential for injury, comply with
these safety instructions.
Toro designed and tested this mower for reasonably safe
service; however, failure to comply with the following
instructions may result in persona
Mow across the face of slopes, never up and down
and exercise extreme caution when changing direction
on slopes.
–
Always be sure of your footing on slopes.
•
Never operate the lawn mower with damaged guards, or
without safety devices, for example deflectors and/or
grass catchers, in place.
•
Use low throttle settings when engaging the
traction-clu
Sound Pressure for the 32 RD,
36 RD and 48 RD
The 32 RD has a sound pressure level at the operator’s ear of
87 dBA, which includes an Uncertainty Value (K) of 2 dBA.
The 36 RD has a sound pressure level at the operator’s ear of
87 dBA, which includes an Uncertainty Value (K) of 2 dBA.
The 48 RD has a sound pressure level at the operator’s ear of
92 dBA
This page may be copied for personal use.
1.
The maximum slope you can safely operate the machine on is 20 degrees. Use the slope chart to determine the degree of slope
of hills before operating. Do not operate this machine on a slope greater than 20 degrees. Fold along the appropriate line
to match the recommended slope.
2.
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Keep safety signs clear and visible, replace any decal that is damaged or lost.
320006
1.
Height of cut
40-13–010
1.
Cutting hazard of hand
2.
Cutting hazard of foot
95-5537
1.
Read the Operator's
Manual for i