TRAK 3ntr Series Quick Start Manual

SPFU Installation Quick Start Guide Covers Current Models: • 3ntr A2 • 3ntr A4 2615 Homestead Place Rancho Dominguez, CA 90220-5610 USA T | 310.608.4422 | F | 310.764.2668 Service Department: 800.367.3165 e-mail: [email protected] | [email protected] | web: www.trakmt.com Document: P/N 32230 V ...

be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, mechanical, photocopying, recording or otherwise, without the prior written permission of Southwestern Industries, Inc. While every effort has been made to includ ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide Table of Contents 1 Introduction ............................................................... 1 2 Clean Nozzle Procedure .............................................. 1 2.1 Clean Nozzle Procedure Overview: ..................................... ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide 1 Introduction This guide outlines the process to install the Soft Polymer Feeder Unit (SPFU) to Nozzle #1 of your TRAK 3ntr A2 or A4 printer. Before you can install the SPFU, you must complete the Clean Nozzle procedure (also outlined within thi ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide Figure 2.2.1 Selecting Change Filament from Prepare Menu 3) Assuming filament has been previously loaded, Select Change Filament “Extruder #1” Figure 2.2.2 Selecting Extruder for Change Filament 4) The selected extruder will begin heating up a ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide Figure 2.2.5 Disengage filament feeder Figure 2.2.6 Latched & Unlatched Filament Feeders ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide 7) Pull the filament from the feeder, rewinding the filament onto the spool. Figure 2.2.7 Pulling old filament out of feeder unit 8) Thread the end through the opening on the spool to keep it from de-coiling. Figure 2.2.8 Secure filament end to s ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide 2.3 Load Cleaning Filament 1) Obtain the cleaning filament (Hollow nylon filament specially for nozzle cleaning). Figure 2.3.1 Nozzle Cleaning Filament (Nylon) 2) Trim off several mm to remove bends, dirt, tape, or damage. Straighten as needed. ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide 4) Feed the filament into the feeder unit and keep feeding until the end stops at the extruder. Release the feeder handle. Verify the locking “lip” is disengaged. Figure 2.3.4 Engage the filament feeder 5) The locking lip is now engaged. The m ...

Southwestern Industries, Inc. TRAK 3ntr 3D Printers – SPFU Installation Quick Start Guide 6) Press the button on the jog wheel. The LCD will display “Priming #X” as it purges some filament. Upon completion, the LCD will display “Change #x Complete” to indicate completion. Figure 2.3.6 LCD Display while new filament is priming 7 ...