Bodine B50LP Installation Instructions

Text of Bodine B50LP Installation Instructions

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

! IMPORTANT SAFEGUARDS ! WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: SAVE THESE INSTRUCTIONS THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY. THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. Bodine © 2018 Signify Holding. All rights res

WARNING: TO PREVENT HIGH VOLTAGE FROM BEING PRESENT ON RED & YELLOW OUTPUT

LEADS PRIOR TO INSTALLATION, INVERTER CONNECTOR MUST BE OPEN. DO NOT JOIN INVERTER CONNECTOR UNTIL INSTALLATION IS COMPLETE AND AC POWER IS SUPPLIED TO THE EMERGENCY BALLAST. NOTE: Make sure that the necessary branch circuit wiring is available. An unswitched source of power is requir

When AC power is applied, the charging indicator light is illuminated, indicating the battery is being charged. When power fails,

the emergency ballast automatically switches to emergency power, operating one or two lamps at reduced illumination. When AC power is restored, the emergency ballast returns to the charging mode and delays AC ballast

TWO (2) LAMP INSTANT START BALLAST

FIG E THREE (3) LAMP INSTANT START BALLAST FIG F THREE (3) LAMP RAPID START BALLAST EMERGENCY BALLAST AND AC BALLAST MUST BE FED FROM THE SAME BRANCH CIRCUIT TYPICAL SCHEMATICS ONLY. MAY BE USED WITH OTHER BALLASTS. CONSULT THE FACTORY FOR OTHER WIRING DIAGRAMS. WIRING DIAGRAMS FOR 1-LAMP EMERGENCY OPERATION FIG G

FIG R ONE (1) 17-215 W LAMP WITHOUT AC BALLAST

WIRING DIAGRAMS for Emergency-Only fixtures FIG S TWO (2) 17-40 W LAMPS WITHOUT AC BALLAST WIRING DIAGRAMS for 2-LAMP emergency operation (2´- 4´, 17- 40 W lamps only) FIG J TWO (2) LAMP INSTANT START BALLAST FIG K TWO (2) LAMP RAPID START BALLAST FIG L THREE (3) LAMP INSTANT START BALLAST E M E R G E N C Y

Bodine Lighting Equipment Owners Instructions: