Bodine BSL310LPST Installation Instructions
Text of Bodine BSL310LPST Installation Instructions
SAVE THESE INSTRUCTIONS
THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Bodine © 2018 Signify Holding. All rights reserved.
236 Mt. Pleasant Rd. • Collierville, TN USA 38017-2752 • Tech Support 888-263-4638 • Fax 901-853-5009 • www.bodine.com
442294629632
BSL310LPST
03/07/19
Ni - Cd
INSTALLING THE EMERGENCY DRIVER
> Disconnect AC power from the LED luminaire.
> Mount the emergency LED driver by the mounting tabs using the supplied screws. The luminaire’s installation
instructions may provide guidance on the recommended mounting location.
> The emergency driver may be remote mounted from the luminaire. If used
WIRING THE EMERGENCY BALLAST
> Select the appropriate wiring diagram to connect the emergency driver to the AC driver and LED load.
Make sure all connections are in accordance with the National Electrical Code and any local regulations.
> After installation is complete, supply AC power to the emergency driver and join the converter connector.
> At th
During normal operation, AC power is applied and the self-testing emergency driver charges the battery. Connecting the
(red and white) Converter connector wires enables the emergency circuit and supplies power to the control/monitor circuit
and charging indicator light. The self-testing emergency driver continually monitors the unit health. Should the unit d
Failure Status will be reset when the unit passes:
• The next automatic test, or
• Briefly pressing the 2 wire ITS, or
• A power failure exceeding 10 seconds.
NOTE: The converter connector (red and white wires) must be connected for the AC driver to
operate normally.
5
EMERGENCY DRIVER AND AC DRIVER MUST BE FED FROM THE SAME BRANCH CIRCUIT
TYPICAL S