Uplift Desk Power & Data Rail Installation Instructions Manual

call 800-349-3839 or email [email protected] Patent Pending, ©2020 UPLIFT Desk®. All Rights Reserved 355 lb two person assembly Power & Data Rail Modular system for power and data solutions. ® ...

Single row end foot (PDC005-FOOT-SE) Single row center foot (PDC005-FOOT-SC) Dual row end foot (PDC005-FOOT-DE) Dual row center foot (PDC005-FOOT-DC) Privacy panel brackets (PDC005-PRV) (Privacy Panels shipped separately) Short wire trays (PDC005-TRAY-SHT) Long wire trays (PDC005-TRAY-LNG) Long rail assembly (PDC005-RAIL-L ...

3 Serving as a central spine in a group of benched workstations or a border around other con- figurations, the Power and Data Rail allows you to provide power and data to the following common configurations and many more. Dual Sided Row H-Shape 3-Pack Single Sided Row ...

4 M6x6 Set screw (installed in post) Comes pre-assembled Consists of: Upper post Inner sleeve (inside) Bottom post Step 1 The posts are designed with recommended height setting indicator lines on the Bottom post for UPLIFT V2 and UPLIFT V2-Commercial desks. Using the ...

5 Step 1 The Square post feet are designed for Single Sided or Dual Sided Row configurations as shown in the dia- grams. Regardless of the length of the row of desks, if you are using UPLIFT V2 and UPLIFT V2-Commercial desks, the end posts in the run will require End ...

6 Pictured here: Short Rail (33.5” - 48.8” width adjustment between posts) All rails come pre-assembled Consisting of: Cover Rail housing Rail extensions (qty 2) Also available: Long Rail (51.5” - 73.8” width adjustment between posts) Step 1 The Covers are not ...

7 Step 4 Move an UPLIFT V2 desk up to your first Rail and Post assembly. Slide the Posts in or out to align the holes in the Post feet with the leveling glides in the back of the desk feet as shown. Then, lift the desk slightly on each side and set the desk glides int ...

8 Use Single row end feet at “A” locations, facing inward. Use Single row center feet at “B” locations, facing in- ward. Use Dual row end feet at “C” locations, perpendicular to the rails. Use Single row end feet at “A” locations, facing inward. Use Si ...

9 M5x10 Flat head screw (qty 6) 120-Degree foot (qty 3) 3mm Allen wrench Height setting for V2-Commercial Frames Height setting for V2 Frames Step 1 The posts are designed with recommended height setting indicator lines on the Bottom post for UPLIFT V2 and UPLIFT V2-C ...

10 Step 3 Each 120-Degree post is used with three Square posts in 3-Pack and Dog Bone Shape configurations. Once the posts for a 3-Pack configuration are assembled, position them as shown to the left approximately where they will be located once the Power and Data Rai ...