Pulsar AWZ516 Manual 

Text of Pulsar AWZ516 Manual 

Time relay module.

Edition: 5 from 01.03.2018 EN* Supersedes the edition: 4 from 15.01.2015 Features:  10 ÷ 16V DC power supply  18 time-logic programs  The range of measured times: up to 100 hours  High precision t

2. Components arrangement.

The figure below shows the arrangement of the most important components and connectors of the relay module. Fig. 1. The module’s view. Table 1. The description of components and connectors of the module. Number [Fig. 1] Description Connector: +12V- - the module’s power supply, DC voltage S+ - control input supplied by the

3. Programming the time module.

If there is no action for more than 30 seconds when changing the parameters settings, the module automatically exits the programming mode without saving the changes. 1) Press the and buttons simultaneously for 5 seconds to enter the programming mode. The „PR” LED will blink and the number of currently saved program wil

4. Preview - the parameters of currently set program.

The program number and time module parameters can be checked by pressing the OK button for 3 seconds. The "PR" LED will light up and the number of the currently set program will be displayed . Use the or buttons. The information about the current time parameters of the program - according to the diagr

6. Timer programs.

PR0 - Permanent on or off. In this mode, press the "OK" button to permanently switch on or off the relay. The relay state is remembered when power is disconnected and it is immediately restored when switched on. PR1 - T1 time activation delay with locking option – single cycle. The countdown of the T1 time takes place automatically aft

Pulsar Control Unit Owners Instructions: