Compaq DS10 Manual 

• Determine Base Zero • Mark and Prepare the Rails • Install the Rails • Attach the Rackmount Ears • Insert and Secure the System • Check Power and Secure Cables • For More Information WARNING: To prevent injury, access is limited to persons who have appropriate technical training and experience. Such persons are expected to understand the hazards of working within this equipment and take measures to minimize danger to themselves or others. Rackmount Guidelines. • A maximum of six systems per each power controller ...

There are two threaded guide pins on the rails: one on the front of each rail, and one on each rear side. In case the holes in your rackmount cabinet require smaller guide pins, a second set of smaller pins has been included in the kit. Replace the pins if necessary. • Insert the front guide pin, aligning the screw hole to the front C-clip. See Figure 4, –. Push the rail in. • Insert the rear guide pin into the side rail, aligning the screw holes to the rear U-clips. Push the rail in toward the side of the rackmount cabinet (see —). • Secure with four screws. See ˜. Figure 4 Installing the Rails PK1034-99 2 3 1 Attach th ...

• Select the correct power setting (see Figure 8). • Connect the power cord. • Turn the power cord latch clockwise to secure the power cord. • Tighten the latch with a screwdriver. • Route the power cord over the back of the rail, into the rackmount cabinet side area. • Continue cabling (see AlphaServer DS10 Quick Setup poster). When all cabling is complete, connect power cord to the power controller unit. Figure 8 Securing Power 115V 230V PK1047-99 After securing the power cord with the safety latch, route the power cords over the rails and into the side of the cabinet. For More Information • H9A10-M-Serie ...