Assa Abloy ML22HPH Instructions

INSTRUCTIONS An ASSA ABLOY Group brand CHANGING THE MASTER-CODE 1. Press for 4 seconds (green LED starts to blink) 2. Enter Master-code (factory setting 1111) and press 3. Enter new Master-code (4 - 12 numbers) and press 4. Enter new Master-code again and press Short melody and LED blinks several times when changed successfully. Note. Master-code must be changed before adding User-code. ADDING USER-CODE Enter User-code (4 numbers) or Press and enter User-code (5 - 12 numbers) and press Short melody and LED blinks several times when changed successfully. Note. Opening with the Master-code will delete the User-code. CHANGING THE USER-CODE 1. Enter User-code and press 2. Enter new User-code (4 numbers) or 2. Press and enter User-code (5 - 12 numbers) and press Short melody and LED blinks several times when changed successfully. OPENING WITH THE MASTER-CODE + Master-code + OPENING WITH THE USER-CODE User-code MELODY OFF and pressed simultaneously for 2 seconds MELODY ON and pressed simultaneously for 2 seconds RESET (if there is unknown problem and lock does not work. Does not delete codes) Press and simultaneously (Short melody and green and red LED blinks) 2.9.2015 Rev.0 CARE INSTRUCTIONS Use a damp, soft cloth for removing stains and fingerprints from the lock. For grease and other accumulated dirt use cloth with mild cleaning agent. The lock does not need to be greased. Copyright® Abloy Oy Joensuu Factory

There will be battery warning alarms, 5 beeps, while opening and closing the lock. Use 3x 1,5V AAA alkaline batteries only. Batteries last for 3 years. A standard DC 5V charger with Micro USB cable can be used to supply the power. USB-connector An ASSA ABLOY Group brand PROBLEM SITUATIONS 1. Couple the “Reset” points with sharp tweezers or similar. 2. press and simultanously. 3. Remove “Reset” coupling. Short melody and LED blinks several times after reset. Master-code resets to 1111. RESET TO FACTORY SETTINGS EMERGENCY OPENING Use emergency opening if the lock does not work at all (breaks the lock). 1. Drill the lock at the spot as shown in pictures below. 2. Remove the knob and open the lock with the screwdriver. ø2 Min. 39 mm Spot ø2 Min. 39 mm Spot Copyright® Abloy Oy Joensuu Factory