Front Runner SSDR010 Manual 

Text of Front Runner SSDR010 Manual 

Front Runner SSDR010 INSTALL TIME: 30 Mins

REV_A00 IMPORTANT WARNING! IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN- JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPEC

Here is what you are looking at for SSWO008:

You will need: 10 mm Flat & Socket Wrench 4 mm Hex Key a Friend Additional Fasteners and Tools de- pending on application REV_A00 Item # Quantity Description 1 1 DRAWER 2 4 TURNBUCKLE 3 4 WING NUT 4 4 D-RING 5 4 M6 x 20 HEX BOLT 6 4 M6 SPRING WASHER 7 4 M6 x 19 FLAT WASHER 8 6 EYE NUT 9 6 STUD PLATE 10 6 NYLON WASHER 11 4 60mm C-HOOK 12 3 M8 x 16 HEX BOLT 13 3 M8 CHANNEL NUT 14 3 M8 x 2

Loosen the round end of the four Turn Buckles (Item 2). Screw a M6 Wing Nut (Item 3) onto each round

end and reassemble the Turn Buckle as shown. ( ) A Assemble the M6 Eye Nuts and Nylon Washers (Items 7 & 8) to the Stud Plates (Item 9) as shown. ( ) B REV_A00 ( ) c Assemble two D-rings (Item 4) to either side of the Drawer as shown using the M6 x 20 Hex Bolts, M6 x 19 Flat Washers and M6 Spring Washers as shown.

Install drawer cont...

REV_A00 Slide a Channel Nut (Item 13) into each end of the Track (Item 16). Place the Track under the front of the Drawer System and line the Channel Nuts in the Track up with the mounting holes in front corners of the Drawer System. Loosely secure the Track in position using the two M8 x 16 Hex Bolts, two M8 x 25 Flat Washers and two M8 Springs Washers (Items 12, 14, 15). Center the Track from left to right and fasten. ( ) D ( F
Install drawer cont... REV_A00 With the Turn Buckles and C-hooks in position, work out how best to secure the "hook end " of the Turn Buckle to the vehicle. Referring to the image below, note that the Turn Buckles must all pull away form each other in order to prevent the Drawer System from moving one secured into position. As mentioned on the front page, you may require additional fasteners and tools at this stage in order to create suitable mounting po

Should you wish to use the Eye Nut

assemblies from Step 2B as tie down points, they can be slid into any of the three top extrusions as shown and tightened in the required position. ( ) I Congratulations, you have completed your installation. Take a step back and admire your work. Good Job! ( J ) INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner dealer in person or online. ( ) A

Front Runner Automobile Accessories Owners Instructions: