Sealey PC380M110V Manual 

Text of Sealey PC380M110V Manual 

38L DUST-FREE WET & DRY INDUSTRIAL

VACUUM CLEANER STAINLESS STEEL DRUM CLASS M FILTRATION MODEL NO: PC380M110V Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND

DO NOT pull or carry by cable, use cable as handle, close a door on the cable, or pull cable around sharp edges or corners.

9 If the supply cord is damaged, it must be replaced by the manufacturer, a qualified service agent or similarly qualified persons in order to avoid a hazard. 8 DO NOT handle the plug or vacuum cleaner with wet hands. 9 Frequently check that the float valve positioned underneath the motor is able to move freely. 8 DO NOT use this va

2 Carry handle

3 Wing knob 4 Power regulator 5 Latch 6 Rear wheel 7 Front castor 8 Container 9 Cover gasket 10 Suction port 11 Power take off socket 12 On/off switch 13 Filter cleaning button 14 Air flow indicator 15 Hose storage rack 16 Accessory storage 17 Squeegee inserts 18 Brush inserts (pre-installed) 19 Floor nozzle 20 Suction hose 21 Crevice tool 22 Dust bag (x5) 23 Round dust brush 24 Power tool hose adaptor 25 Metal extensio

To use disposable bag, place the disposable bag into the container, and fully fit the tank liner flange onto the inlet stub. Fold the top

edge of the tank liner over the rim of the container (Fig.7). 5.11. To use a disposable bag and a dust bag together, place the disposable bag into the container and fully fit the disposable bag flange onto the inlet stub, and fold the top edge of the disposable bag over the rim of the container, then fully fit the

If applicable, connect the vacuum suction hose to the dust extractor connector on your tool with the supplied adaptor.

6.2.3. Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance has been switched off, the vacuum cleaner switches off following a time lapse (around 5 seconds) to allow the suction tube to be emptied. 6.

To prepare your vacuum cleaner for dry vacuuming, install the cartridge filter over the filter cage. Carefully push filter until it sits flush

forming a tight seal. Tighten the filter retainer lock clockwise to secure against the internal filter cage (Fig. 18). 6.6.2. Install the dust bag and/or the disposable bag onto the suction port inlet. Refer to sections 5.9 & 5.10 for installation instructions. IMPORTANT: Before picking up dust with occupati

Sealey PC380M110V Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

 01284 757500  01284 703534  [email protected]  www.sealey.co.uk ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requi

Sealey Vacuum Cleaner Owners Instructions: