Troy-Bilt 10030 Operator's Manual

Text of the manual

PRINTED IN U.S.A.

Operator’s Manual FORM NO. 769-00376.fm (6/2002) IMPORTANT: Read safety rules and instructions carefully before operating equipment. TROY-BILT LLC. P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- c

TABLE OF CONTENTS

Content Page Important Safe Operation Practices ...................................................................................3 Assembling Your Snow Thrower........................................................................................5 Know Your Snow Thrower ..................................................................

SECTION 1: IMPORTANT SAFE OPERATION PRACTICES

DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to obse

Never run an engine indoors or in a poorly ventilated

area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 6. Do not operate machine while under the influence of alcohol or drugs. 7. Muffler and engine become hot and can cause a burn. Do not touch. 8. Exercise extreme caution when operating on or crossing gravel surfaces. Stay aler

SECTION 2: ASSEMBLING YOUR SNOW THROWER

Unpacking • Remove staples from the top, sides, and ends of the shipping crate. • Set panels aside to avoid tire punctures or personal injury. • Remove and discard plastic bag that covers unit. • Roll the unit out of the crate. • Check the crate for loose parts before discarding. Loose Parts • The augers

Unwrap the headlight wire which is attached to the

headlight, beneath the handle panel. Wind the headlight wire around the lower right handle until excess slack is removed. See Figure 4. • Plug the wire from the headlight into the alternator lead coming from the right side of the engine underneath the fuel tank. Figure 4 Chute Clean-Out Tool

Tire Pressure (Pneumatic Tires)

The tires are overinflated for shipping purposes. • Check tire pressure. Maintain pressure between 10 and 14 psi. NOTE: If the tire pressure is not equal in all tires, the unit may pull to one side or the other. SECTION 3: KNOWING YOUR SNOW THROWER • Compare the figure below and description of controls in this

Traction Control / Auger Control Lock

The traction control is located on the right handle. Squeeze the traction control to engage the wheel drive. Release to stop. This same lever also locks the auger control so you can operate the chute crank without interrupting the snow throwing process. If the auger control is engaged simultaneously with the traction c

More Troy-Bilt Snow Blower Owners Instructions: